Manufacturing Procedures

3D Design and Assembly Modeling

Product design is made in 3D in accordance with the project and/or customer criteria. If necessary, assembly models are formed together with other hydraulic system elements. After the final checks are made, the manufacturing process begins.

3 Boyutlu Tasarım ve Montaj Modelleme 2

3D Design and Assembly Modeling

3 Boyutlu Tasarım ve Montaj Modelleme 3

3D Design and Assembly Modeling

3 Boyutlu Tasarım ve Montaj Modelleme 4

3D Design and Assembly Modeling

3 Boyutlu Tasarım ve Montaj Modelleme 5

3D Design and Assembly Modeling

CNC Machining Center

  • Minimum error,
  • High processing quality,
  • Minimum manufacturing time,
  • Lower costs
  • Prototype work is completed and turned into mass production of hydraulic blocks are processed in CNC machining center.

Measurement Reporting with 3D Measurement Device (CCM)

  • It is used to extract sample block image or to prepare measurement reports for the production.
  • Possibility to take less than 0.1 mm tolerance on the sample piece,
  • Possibility to take healthy hole center dimensions,
  • Preparing the measurement report of the produced part,
  • Improve production quality,
  • Easily cast complex workpieces into the picture

Hydraulic Valve, Block and Unit Function Tests and Reporting

Functional tests of the brands we represent or the products we manufacture are performed alone or assembled. By adjusting the hydraulic system inputs, it is tested whether the desired values can be achieved.

  • Test setup,
  • It can be adjusted and measured in the 0-400 bar pressure range.
  • Flow adjustment can be made in the range of 0-140 lt / min with power regulation function and proportional control.
  • There are hydraulic cylinders which can be synchronized and high pressure tests on the test device and hydro motors which can adjust counter balance, speed and priority.
  • There are temperature sensors at 5 different points and pressure sensors at 7 different points on the system.
  • It was isolated from the test assembly drive motor pump group testing environment and reduced noise levels.
  • Test scenarios can be prepared on the electronic control panel and test cycles can be set up according to the desired number of cycles.
Hidrolik Valf, Blok ve Ünite Fonksiyon Testleri ve Raporlama

Hydraulic Valve, Block and Unit Function Tests and Reporting